Closed IIREDII closed 2 years ago
Update, issue seems to be micro stepping too much, sometimes you can micro step 4/5 times sometimes you cannot, If I micro too much down, then up then down over and over, that's when it basically freezes and stops taking commands, If the micro step doesn't move the z, if I set the z using the position and roll it up to like 1, then roll it to my value of -.10 then I can micro step to the value I need. This seems to have worked, then manual adjust has allowed me to micro adjust specific points that weren't 'adjusting' during the mesh setup. I can still bork the full new mesh setting, but glitches are expected.
Manual Mesh 5x5 firmware z sometimes moves, z sometimes doesn't move, so you cannot actually confirm/check and set proper mesh value, then "next point' stops working and no longer takes setting commands, have to back out and try again, which resets values of the previous points, so far best I have gotten is 3 properly set in a row before failure.