On the DWIN_SET folder, note you have to change the 0 Start to 00.jpg and 1 English to 1_en. Very minor bug, but everything else works A+++

alexqzd / Marlin

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.

http://marlinfw.org

GNU General Public License v3.0

198 stars 70 forks source link

On the DWIN_SET folder, note you have to change the 0 Start to 00.jpg and 1 English to 1_en. Very minor bug, but everything else works A+++ #38

Open RandomDebugGuy opened 2 years ago

RandomDebugGuy commented 2 years ago

Description

QUICK TIP: I am using a 32GB Micro SD card, which the display won't support. So, I used AOMEI Partition assistant to break it in half to 15.3GB. All the info is at diskpart.com

Steps to Reproduce

Change 0_Start to 00
Change the 1_English to 1_en

Expected behavior: Screen turns blue for a while then red

Actual behavior: Screen boots normal but without new firmware