search

alexqzd / Marlin

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
http://marlinfw.org
GNU General Public License v3.0
198 stars 70 forks source link

Failed to build code with VSCode #47

Open vica153 opened 1 year ago

vica153 commented 1 year ago

I'm trying to up the temp limits to print nylon and it keeps failing when tryin to build the code. I even tried it on a couple of the config files without editing anything in the code and still got the error. Any ideas?

".....platformio\penv\Scripts\platformio.exe 'run'" terminated with exit code: 1"

vica153 commented 1 year ago

Can someone compile UBL-BLToch-10x10 with 300C tempt limit instead of 275C?

Also, you probably shouldn't try more than ~230C on these old Aquilas. I ran my G32 Aquila at 255C for ~5minutes and then the temp suddenly showed 210C and did not come back up. Afterward the extruder doesn't seem to be able to maintain any specific temp I set it to. After sitting for a day it reads 10C hotter than actual ambient, so I think the thermister at least is broken.