search

alexreinert / piVCCU

piVCCU is a project to install the original Homematic CCU3 firmware inside a virtualized container (lxc) on ARM based single board computers.
Apache License 2.0
306 stars 65 forks source link

Problems with adding new Homematic IP actors #386

Closed jackmenimble0 closed 3 years ago

jackmenimble0 commented 3 years ago

Hey Guys,

I'm using a Raspi 4B with pivccu3 and HM-MOD-RPI-PCB. Installation seems to work fine. I get following output:

pi@raspberrypi:~ $ sudo pivccu-info piVCCU version: 3.57.5-57 Kernel modules: Available Raw UART dev: Available Rasp.Pi UART: Assigned to GPIO pins HMRF Hardware: HM-MOD-RPI-PCB Connected via: GPIO (/dev/raw-uart) Board serial: OEQ0310424 Radio MAC: 0x584B55 HMIP Hardware: HM-MOD-RPI-PCB SGTIN: 3014F711A061A7D7098E2498 Radio MAC: 0xB03ACB State: RUNNING PID: 945 IP: 192.168.178.25 CPU use: 15.06 seconds BlkIO use: 62.37 MiB Link: vethpivccu TX bytes: 17.61 KiB RX bytes: 35.16 KiB Total bytes: 52.77 KiB

But I can't add Homematic actors. The actors and HM-MOD-RPI-PCB was already working with Raspi 3B. The actors was many times resetet. What could be the problem?

Thanks a lot!

alexreinert commented 3 years ago

The Raspi 4B produces a lot of interference at 868MHz, which affects especially HmIP with its Listen-Before-Talk. You need at least 50cm distance between the HM-MOD-RPI-PCB and the Raspi.

jackmenimble0 commented 3 years ago

I‘m understandig. But how could I resolve it?

alexreinert commented 3 years ago

As said, you need at least 50cm distance between the HM-MOD-RPI-PCB and the Raspi, e.g. using GPIO ribbon cable or using a HB-RF-USB-2 pcb.

stale[bot] commented 3 years ago

This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.