search

alexreinert / piVCCU

piVCCU is a project to install the original Homematic CCU3 firmware inside a virtualized container (lxc) on ARM based single board computers.
Apache License 2.0
302 stars 64 forks source link

ntpd[317]: unable to create socket on eth0 #455

Closed jht11 closed 1 year ago

jht11 commented 1 year ago

Wahrscheinlich seit dem letzten Update bekomme ich regelmäßig Fehlermeldung zu: ntpd[317]: unable to create socket on eth0 (40) for fd8b:b69e:5b08:42f3:d8ac:24ff:feb3:f9f#123

pi@TSHOME:~$ sudo pivccu-info
piVCCU version: 3.65.8-74
Kernel modules: Available
Raw UART dev: Available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: RPI-RF-MOD
Connected via: HB-RF-USB@usb-0000:01:00.0-1.2 (/dev/raw-uart1)
Board serial: 58A9A70A6A
Radio MAC: 0xFF0A6A
HMIP Hardware: RPI-RF-MOD
Connected via: HB-RF-USB@usb-0000:01:00.0-1.2 (/dev/raw-uart1)
SGTIN: 3014F711A0001F58A9A70A6A
Radio MAC: 0xB8D78D
State: RUNNING
PID: 10634
IP: 10.220.205.112
IP: 192.168.188.24
IP: 2a02:810d:f00:f28:d8ac:24ff:feb3:f9f
IP: fd00::d8ac:24ff:feb3:f9f
CPU use: 9387.80 seconds
BlkIO use: 13.69 GiB
Link: vethpivccu
TX bytes: 326.41 MiB
RX bytes: 6.09 GiB
Total bytes: 6.41 GiB

stale[bot] commented 1 year ago

This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.