search

alexreinert / piVCCU

piVCCU is a project to install the original Homematic CCU3 firmware inside a virtualized container (lxc) on ARM based single board computers.
Apache License 2.0
302 stars 64 forks source link

HmIP-RFUSB with HM-MOD-RPI-PCB together #465

Closed Sirmike2 closed 1 year ago

Sirmike2 commented 1 year ago

Hi,

I wanted to use the HmIP-RFUSB with HM-MOD-RPI-PCB together on a raspberry Pi 4, but the piVCCU only use the HM-MOD-RPI-PCB adapter. Both adapters are recognized as /dev/raw-uart and /dev/raw-uart1.

Is it possible to use both adapter with piVCCU3 or is this not possible?

Thanks for answering!

BR

alexreinert commented 1 year ago

Both modules are capable of dual Copro mode, why should when two modules be used? And because of the dual copro, it is not possible two use both modules as this would require two instances of multimacd, which is not possible.

Sirmike2 commented 1 year ago

Ah ok, thanks for the answer.

I have a lot of old RF Homematic equipment and some new HmIP stuff. For these things I need a bigger range, that is why I am using the old HM-MOD-RPI-PCB with an external antenna. I only need the HmIP-RFUSB for the HmIP-wired system. The HM-MOD-RPI-PCB could not handle the new wired system, only the normal HmIP equipment. I think the USB Stick will not have the same range, that I will get all my devices. That was the reason, why I would like to use both of them.

BR

stale[bot] commented 1 year ago

This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.