Closed Nasenloch closed 1 year ago
Wurde der während des Updates geforderte Reboot gemacht?
Problem gelöst!
journalctl -xe ░░ An ExecStart= process belonging to unit pivccu-dkms.service has exited. ░░ ░░ The process' exit code is 'exited' and its exit status is 1. May 10 11:10:29 raspberrypi systemd[1]: pivccu-dkms.service: Failed with result 'exit-code'. ░░ Subject: Unit failed ░░ Defined-By: systemd ░░ Support: https://www.debian.org/support ░░ ░░ The unit pivccu-dkms.service has entered the 'failed' state with result 'exit-code'. May 10 11:10:29 raspberrypi systemd[1]: Failed to start piVCCU DKMS Modules. ░░ Subject: A start job for unit pivccu-dkms.service has failed ░░ Defined-By: systemd ░░ Support: https://www.debian.org/support ░░ ░░ A start job for unit pivccu-dkms.service has finished with a failure. ░░ ░░ The job identifier is 516 and the job result is failed. May 10 11:10:29 raspberrypi systemd[1]: Dependency failed for piVCCU. ░░ Subject: A start job for unit pivccu.service has failed ░░ Defined-By: systemd ░░ Support: https://www.debian.org/support ░░ ░░ A start job for unit pivccu.service has finished with a failure. ░░ ░░ The job identifier is 515 and the job result is dependency. May 10 11:10:29 raspberrypi systemd[1]: pivccu.service: Job pivccu.service/start failed with result > May 10 11:10:29 raspberrypi systemd[1]: Condition check resulted in Monitor HB-RF-ETH being skipped. ░░ Subject: A start job for unit monitor-hb-rf-eth.service has finished successfully ░░ Defined-By: systemd ░░ Support: https://www.debian.org/support
sudo apt install --reinstall raspberrypi-bootloader raspberrypi-kernel raspberrypi-kernel-headers
Neustart und er rennt wieder...
Trotzdem vielen Dank!
Nach Durchführung des aktuellen Updates (sudo apt-get update; sudo apt-get upgrade) erreiche ich die CCU nicht mehr. Auch eine Neuinstallation von pivccu hat nichts gebracht.
sudo pivccu-info bringt diese Info hervor:
,piVCCU version: 3.69.7-80 Kernel modules: Not available Raw UART dev: Not available Rasp.Pi UART: Assigned to GPIO pins HMRF Hardware: unknown HMIP Hardware: unknown State: STOPPED
Danke!