Open Xenomorphdelombre opened 6 years ago
+1 to this. I downloaded this plugin at the recommendation of a friend and since then my prints have been totally fubar. Came here and saw this issue and checked on my printer and it was turned on without me knowing.
Hi @Xenomorphdelombre, in the next release this feature to be released. @kbuechl sorry for the setback.
Thanks!
I installed the plugin and wanted to check all options. After looking around I was satisfied with my changed I saved and uploaded and tried a print which got Under Extruded.
Went back to all options and found the Filament tab which was set to 1.75. I changed it to 1 and my prints were somewhat "ok". Then I found online that this is to enable E in mm3 instead of linear extrusion.
It owuld be good if you'd be reading the setting and showing which is setup in the firmware and the give a checkbox to enable or not, the if enable set filament to whatever it is, with a more detailed explanation on what is E in mm3.
Thanks!