search

amsbr / OctoPrint-EEPROM-Marlin

OctoPrint-EEPROM-Marlin
15 stars 30 forks source link

Not loading eeprom #9

Closed storemanuk closed 7 years ago

storemanuk commented 7 years ago

I've installed the plugin and see it listed with other plugins.

with printer connected I click the plugin from the left navbar then click on Load EEPROM but it doesn't list any of the eeprom settings. Just a blank page apart from a bit of text at the top and the two buttons marlin editor

amsbr commented 7 years ago

Hi @storemanuk

The setting #define EEPROM_SETTINGS is enabled on your firmware?

storemanuk commented 7 years ago

Duh! My apologies,

M503 was disabled in the firmware. I recently uploaded Marlin 1.1.6 using a predefined configuration.h for the CR-10 but this had been disabled to allow other functions to fit in the program memory. I only discovered this last night and changed it. I'd rather have this feature than a boot screen so the boot screen went to give the room required for this feature. My newbie mistake.

amsbr commented 7 years ago

Hi @storemanuk

All right!