in windows7,32bits sometimes channelA voltage or channelB current aren't plotted in pixelpulse window

[luciansin]

steps to follow for obtaining a bug:

1. open pixelpulse
2. put channelA and channelB in source voltage, waveform sinewave, default settings
3. maximaze window
4. press start(if a channel is not plotted anymore,stop capture, change its frequency to 100Hz and press play)
5. if all channels are plotted play a bit with waveforms and change them on both channels, until one channel is not plotted anymore, then change its frequency to 100Hz)

The bug I found is that either the current channel for channelB

or voltage channel for channelA is not displayed unless the right click on the mouse is not pressed on capture button.

[luciansin]

I've found a better way to reproduce the bug:

1. open pixelpulse
2. put channel A and B in source voltage and select any periodic signal (not necessarily the same on both channels)
3. press start 4.1 do a double right click on the channel A fractional or integer part of: a. frequency or b. voltage maximum or c. voltage minimum After you do this channel A voltage and channel B current plots disappear

For channel B do steps 1,2,3, then 4.2 do a double right click on the channel B fractional or integer part of: a. frequency or b. voltage maximum or c. voltage minimum After you do this channel B current plot disappears

All missing plots reappear while right click of the mouse is kept pressed on the capture button. This bug appears only on Windows7, 32bits.