Open evenlund opened 2 years ago
Hi were you able to solve this problem ? I have the same.
My LED went red after flashing the firmware. I launched the CBM_app.py and I was able to connect to it and then the led went green and blinked normally but after disconnecting my smartmesh USB Manager during like 30 minutes the LED blinked red and I wasn't able to connect to it because it wasn't detected (I reset the network with the CLI but it didn't change anything).
I also noticed that the led blink red and green. Is it from the firmware ?
I will try to rollback to the older firmware and check if it works tomorrow
I figured it out: The latest update of main is not working, but if you use the last branch with version number (1.4?) it is working fine. Remember to use the same version for the firmware as the windows software.
Skaff deg Outlook for Androidhttps://aka.ms/ghei36
From: PveOnly @.> Sent: Monday, April 4, 2022 8:08:20 PM To: analogdevicesinc/ev-cbm-voyager @.> Cc: evenlund @.>; Author @.> Subject: Re: [analogdevicesinc/ev-cbm-voyager] Red LED shown after flashing firmware and no contact (Issue #3)
Hi were you able to solve this problem ? I have the same.
My LED went red after flashing the firmware. I launched the CBM_app.py and I was able to connect to it and then the led went green and blinked normally but after disconnecting my smartmesh USB Manager during like 30 minutes the LED blinked red and I wasn't able to connect to it because it wasn't detected (I reset the network with the CLI but it didn't change anything).
I also noticed that the led blink red and green. Is it from the firmware ?
I will try to rollback to the older firmware and check if it works tomorrow
— Reply to this email directly, view it on GitHubhttps://github.com/analogdevicesinc/ev-cbm-voyager/issues/3#issuecomment-1087859097, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AFUFYIUWGHCM52WNIPAV6ODVDMVZJANCNFSM5RHXUKXQ. You are receiving this because you authored the thread.Message ID: @.***>
Thanks a lot, it works !
Hey, sorry to bother you but is the 1.4 firmware version still working fine with you ? I've a path alarms coming from smartmesh and my mote is getting lost so I would like to be sure if it's my fault or just a bug.
The red LED is shown after flashing the latest cbm_104.hex file and resetting the device. I am no longer able to connect to it from the CBM_app.exe demonstrator software.