Did you check that your request is not a duplicate?
Yes, I have checked and this is a new request.
Is your request specific to your setup only or can it benefit to many people?
My request will benefit to many people.
Is your feature request related to a problem? Please describe.
No response
Describe the feature you want
From antclabs web site:
If a 5V or GND wiring defect occurs during printing, the red LED flashes at 80% duty. Please check the 5V or GND line
Alarm : The AI will flash the LED indicator if a problem is detected during a self-test or operation. The 3D printer can read the BLTouch alarm signal, and according to the alarm status, it can stop and pause the 3D printer with preset G-code, as well as operate the BLTouch release, stow, etc. Please do not ignore the alarm signal and make good use of it. It can keep your 3D printer and BLTouch safe.
If the red LED flashes to 80% duty during 3D printing, check the wiring of the red cable (poor wiring). It may be necessary to repair or reinstall the cable.
if the red LED in BLTOUCH flashes at 80% duty right after the 3D printer is switched on, please release it with S60 or S160. It's a message to check Wiring because your 3D printer board is already sending a control signal to BLTouch before BLTouch power is turned on. Don't worry, your 3D printer and BLTouch work perfectly even if the Red LED flashes at 80% duty. It is common for BLTouch control signals to occur at machine startup or a little later.
andrivet
commented
2 years ago
Did you check that your request is not a duplicate?
Yes, I have checked and this is a new request.
Is your request specific to your setup only or can it benefit to many people?
My request will benefit to many people.
Is your feature request related to a problem? Please describe.
No response
Describe the feature you want
From antclabs web site:
If a 5V or GND wiring defect occurs during printing, the red LED flashes at 80% duty. Please check the 5V or GND line
Alarm : The AI will flash the LED indicator if a problem is detected during a self-test or operation. The 3D printer can read the BLTouch alarm signal, and according to the alarm status, it can stop and pause the 3D printer with preset G-code, as well as operate the BLTouch release, stow, etc. Please do not ignore the alarm signal and make good use of it. It can keep your 3D printer and BLTouch safe.
If the red LED flashes to 80% duty during 3D printing, check the wiring of the red cable (poor wiring). It may be necessary to repair or reinstall the cable.
if the red LED in BLTOUCH flashes at 80% duty right after the 3D printer is switched on, please release it with S60 or S160. It's a message to check Wiring because your 3D printer board is already sending a control signal to BLTouch before BLTouch power is turned on. Don't worry, your 3D printer and BLTouch work perfectly even if the Red LED flashes at 80% duty. It is common for BLTouch control signals to occur at machine startup or a little later.
Additional context
https://makemendel.com/bltouch-blinking-red-during-print/
Have you provided enough and precise information?
Yes, I have provided precise information in the Additional context box.