Open m4rtinvdbij opened 2 years ago
Will you also simulate the infamous oil pressure drop of the VR6 which occasionally resulted in catastrophic engine failure? Like rods punched through the block...
The VR6 was a good engine, as long as oil pressure was good and the timing chain tensioners did their job...
I'm fiddling with this project and i'm trying to recreate a VR6 engine.
But i think i get stuck at using 4 camshafts and the generic cylinder head.
The name VR6 comes from the [German] initials for a [V engine] (German: V-Motor) and a [straight (inline) engine] (German: Reihenmotor), therefore the VR engine is described as a "Vee-Inline engine" (VR-Motor).
VR6 engines share a common [cylinder head] for the two banks of cylinders. Only two [camshafts] are needed for the [engine], regardless of whether the engine has two or [four valves] per cylinder.
https://en.wikipedia.org/wiki/VR6_engine
Ideally there would have to be 1 custom VR head, wich can be used on both cylinder banks, and to go along with it, just one set of camshafts.