search

anmaped / openfang

The openfang is a bootloader, kernel and toolchain for devices using Ingenic T10 and T20 SOC
GNU General Public License v3.0
185 stars 43 forks source link

Wyze Pan V2 _ Firmware not flashing #68

Open MyCodeRocks opened 1 year ago

MyCodeRocks commented 1 year ago

Hi all,

Firstly, Some Camera Info: Bought two of the following

  1. Wyze Pan V2 - Bought - Aug 2023 - Current firmware on the camera 4.49.1.25

  2. FCC ID 2AUIUWYZECP2A (on both) FCCID - Pics:

  3. All https://fccid.io/2AUIUWYZECP2A

  4. Internal https://fccid.io/2AUIUWYZECP2A/Internal-Photos/Internal-Photos-5656183.iframe

Willing to open it up and take pics if needed. Also willing to do some testing if needed

Wanted to figure a few things out first: Question: In order to get Openfang to work you first have to flash the Xiaomi-Dafang-Hacks firmware to the camera?

If so this is what I have tried:

I tried the procedure below on two different SD cards to try and remove the "try different SD Cards" I have x1 16Gig SD card and x1 32GIG Trancend SD Card. Both procedures below I tried with FAT32 - Formatted at full capacity i.e. (16Gigs and 32Gigs) and then formatted with just a 512mb FAT32 Partition.

Partition Type: Primary Format type: FAT32

I have tried the following on the Full capacity and 512MB FAT32 Partitions: Xiaomi-Dafang-Hacks/hacks/cfw/wyzecam_v2 > Found here https://github.com/EliasKotlyar/Xiaomi-Dafang-Hacks/tree/master/hacks/cfw/wyzecam_v2 Firmware versions tried:

  1. cfw-1.0.bin
  2. cfw-1.1.bin
  3. cfw-1.2.bin

None worked: What does none work mean: As per above different SD cards different formatting partitions tried - same result SD Card in slot > Hold Setup In > Apply power > Hold Setup for 10Seconds > Light remains Orange and within 10 - 12 seconds base starts turning > "Ready for setup" is heard.

Folders written to SD card with demo.bin> record timelapse

I have also tried the Wyze firmware that they supply for RSTP stream / WebCam found here: https://support.wyze.com/hc/en-us/articles/360041605111-Webcam-Firmware-Instructions

This is the same procedure as above > SD Card > demo.bin > Hold setup before and after applying power > Same outcome

I cant seem to get this to work no matter what I try - Any suggestions or testing I can do? Very familiar with hardware "hacking" so willing to do testing if someone that knows how to get these things to work for the broader community OR also very happy to be shown where I have gone wrong.

OR if there is an alternative firmware to flash other than Xiaomi-Dafang-Hacks OR if there is a downgrade firmware i first have to flash.

MyCodeRocks commented 1 year ago

For anyone checking to see if it will work seems like a HW refresh on the Wyze Pan Cam V2 - it now runs a T31(HL_PAN2) chip. So I doubt any of this firmware will work.