search

anoved / gpxtruder

Make 3D-printable elevation models of GPX tracks.
http://gpxtruder.xyz/
MIT License
71 stars 23 forks source link

Scaling of the routes #44

Open popeyeatsea opened 4 years ago

popeyeatsea commented 4 years ago

Hello, can you make an option to set a scale for the routes, instead of a minium physical size,I printed two but they both came out at about the same size oven though one was about half the size (in area covered). Otherwise great for me thanks.

ghost commented 4 years ago

Hi when did you print these, just trying to work out how i go about my problem, was there any faults at all?

popeyeatsea commented 4 years ago

Hi, last week, no faults with the actual print out, even test 3d printed them both, that's when I realised they both had been printed to roughly the same size, even though they should have been significantly different, ie one scaled up and one down?! Apart from that all goo, I can manually measure and scale if need though!

mad73923 commented 3 years ago

Added a scalebar in #46 . I think scaling to a specific value shouldn't be that complex