GUUDGO GD-SC03 Snowman - No Wifi - SSH works - No WIFI ???

[zibous]

Hi I have installed readonlyhack-v0.1.zip on the sd-card. Look that it is working:

Nmap scan report for webcam.local (10.1.1.24)
Host is up (0.0051s latency).
Not shown: 992 closed ports
PORT     STATE SERVICE
21/tcp   open  ftp
22/tcp   open  ssh
23/tcp   open  telnet
80/tcp   open  http
554/tcp  open  rtsp
7103/tcp open  unknown
8001/tcp open  vcom-tunnel
8080/tcp open  http-proxy

ssh is working..

But I can't set up WIFI because I get the message that I should set it up, but I can't see the camera in the WiFi. What can I do to activate the WIFI? Is there a way to do this through the configuration?

wlan0 IEEE 802.11b ESSID: "" Nickname: "<WIFI @ REALTEK>"
           Mode: Monitor Frequency: 2.417 GHz Access Point: Not-Associated
           Sensitivity: 0/0
           Retry: off RTS thr: off Fragment thr: off
           Encryption key: off
           Power management: off
           Link Quality: 0 Signal level: 0 Noise level: 0
           Rx invalid nwid: 0 Rx invalid crypt: 0 Rx invalid frag: 0
           Tx excessive retries: 0 Invalid misc: 0 Missed beacon: 0

Thanks

[zibous]

.. create a cls.conf on the root directory:

[cls_server]
ssid = WIFINETWORKSSID
passwd = theSecretOne!