I've just made a part for the IN-12 Russian nixie tube for a project(8 bit
relay + valve computer) I'm working on because using headers with named pins
were getting unwieldy and not very elegant.
Since I spent a bit of time on making it I felt it would be nice to share it
with everyone. As far as I can gather from several datasheets of the same part
there is slight deviation to the dimensions of the glass envelope which means
the dimensions of the part in Fritzing is only accurate to within 1mm. Which is
likely within tolerances for glass working anyway so I don't believe this to be
an issue. The PCB pin holes, however, are consistent and should be correct but
it's always wise to get a pair of calipers on it before you make pcbs with
tubes.
I'm also posting on here to ask if there is any interest in a finished set of
IN series nixies? If there is some desire for these tubes please suggest which
ones are most requested. I'll already be doing the IN-18 variety which is
commonly used in 'Nixie Clocks'.
Screenshot of part:
https://dl.dropboxusercontent.com/u/45524288/IN-12_NIXIE_12_screenshot.png
Download:
https://dl.dropboxusercontent.com/u/45524288/Programming/IN-12%20Nixie%20tube.fz
pz
Thanks for any suggestions. :)
Original issue reported on code.google.com by Sparks...@gmail.com on 5 Jan 2015 at 10:47
Original issue reported on code.google.com by
Sparks...@gmail.com
on 5 Jan 2015 at 10:47