search

aparcar / openwrt

Staging tree of Paul Spooren
Other
8 stars 1 forks source link

FS#35 - mynet-n750 factory images don't find root partition #61

Closed aparcar closed 2 years ago

aparcar commented 2 years ago

The LEDE Project factory images do not boot when flashed from either the web interface or the emergency recovery web site.

Boot logs as of r813: verify_seama: data=0x81000000, size=3406568 SEAMA ========================================== magic : 5ea3a417 meta size : 24 bytes meta data : signature=wrgnd13_wd_av image size : 0 bytes

SEAMA ========================================== magic : 5ea3a417 meta size : 36 bytes meta data : dev=/dev/mtdblock/1 meta data : type=firmware meta data : meta data : image size : 3406464 bytes checksum : 8969D9077B2CAAF8CE87548FC252A30A digest : 8969D9077B2CAAF8CE87548FC252A30A Selected !!!

(ENV) begin addr=0x9f070000,end=0x9ffeffff Erase Flash from 0x9f070000 to 0x9ffeffff in Bank # 1 First 0x7 last 0xfe sector size 0x10000 254 Erased 248 sectors write addr: 9f070000

Write runtime image into flash...OK,dest addr=0x9f070000 Upload file OK!

U-Boot 1.1.4 (Mar 26 2012 - 21:53:42)

SVN revision: 51 Target board: WRG-ND13

DRAM: sri Wasp 1.2 wasp_ddr_initial_config(255): (32bit) ddr2 init 128 MB Top of RAM usable for U-Boot at: 88000000 Reserving 242k for U-Boot at: 87fc0000 Reserving 192k for malloc() at: 87f90000 Reserving 44 Bytes for Board Info at: 87f8ffd4 Reserving 36 Bytes for Global Data at: 87f8ffb0 Reserving 128k for boot params() at: 87f6ffb0 Stack Pointer at: 87f6ff98 Now running in RAM - U-Boot at: 87fc0000 id read 0x100000ff flash size 16 MB, sector count = 256 Flash: 16 MB pci_init_board: PCIe PLL not set for 40MHz refclk In: serial Out: serial Err: serial Net: ag934x_enet_initialize... wasp reset mask:c03300 WASP ----> S17 PHY * : cfg1 0x7 cfg2 0x7114 eth0: 00:90:a9:ad:67:21 athrs17_reg_init: complete eth0 up GIGA: athrs17_link_down all port... eth0 Hit any key to stop autoboot: 0

Booting image at 9f070000 ...

Verifying Checksum ... Uncompressing SEAMA linux.lzma ... OK do_boot_linux entry = 80002000

Transferring control to Linux (at address 00000000) ...

Giving linux memsize in bytes, 134217728

Starting kernel ...

OpenWrt kernel loader for AR7XXX/AR9XXX Copyright (C) 2011 Gabor Juhos <juhosg@ openwrt.org> Decompressing kernel... done! Starting kernel at 80060000...

[ 0.000000] Linux version 4.4.14 (openwrt@ openwrt.crc.id.au) (gcc version 5.3.0 (LEDE GCC 5.3.0 r418) ) #2 Tue Jun 28 14:07:32 UTC 2016 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 0001974c (MIPS 74Kc) [ 0.000000] SoC: Atheros AR9344 rev 2 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 08000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] No valid device tree found, continuing without [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 [ 0.000000] Kernel command line: board=MYNET-N750 console=ttyS0,115200 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,64k(devdata)ro,64k(devconf)ro,15872k(firmware),64k(radiocfg)ro rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes) [ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 125008K/131072K available (3058K kernel code, 162K rwdata, 768K rodata, 292K init, 205K bss, 6064K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Clocks: CPU:560.000MHz, DDR:480.000MHz, AHB:240.000MHz, Ref:40.000MHz [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6825930166 ns [ 0.000010] sched_clock: 32 bits at 280MHz, resolution 3ns, wraps every 7669584382ns [ 0.008295] Calibrating delay loop... 278.93 BogoMIPS (lpj=1394688) [ 0.081138] pid_max: default: 32768 minimum: 301 [ 0.086170] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.093222] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.103130] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.114813] NET: Registered protocol family 16 [ 0.120895] MIPS: machine is WD My Net N750 [ 0.152462] registering PCI controller with io_map_base unset [ 0.401712] PCI host bridge to bus 0000:00 [ 0.406082] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff] [ 0.413443] pci_bus 0000:00: root bus resource [io 0x0000] [ 0.419372] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0] [ 0.426607] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff] [ 0.435105] pci 0000:00:00.0: invalid calibration data [ 0.441018] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1001ffff 64bit] [ 0.448817] pci 0000:00:00.0: BAR 6: assigned [mem 0x10020000-0x1002ffff pref] [ 0.456533] pci 0000:00:00.0: using irq 40 for pin 1 [ 0.462678] clocksource: Switched to clocksource MIPS [ 0.469411] NET: Registered protocol family 2 [ 0.474938] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.482368] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.489178] TCP: Hash tables configured (established 1024 bind 1024) [ 0.496027] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.502253] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.509216] NET: Registered protocol family 1 [ 0.514876] futex hash table entries: 256 (order: -1, 3072 bytes) [ 0.538034] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.544301] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.557084] io scheduler noop registered [ 0.561270] io scheduler deadline registered (default) [ 0.567034] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled [ 0.576566] console [ttyS0] disabled [ 0.600439] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 2500000) is a 16550A [ 0.609633] console [ttyS0] enabled [ 0.609633] console [ttyS0] enabled [ 0.617055] bootconsole [early0] disabled [ 0.617055] bootconsole [early0] disabled [ 0.630332] m25p80 spi0.0: found mx25l12805d, expected m25p80 [ 0.636239] m25p80 spi0.0: mx25l12805d (16384 Kbytes) [ 0.641394] 6 cmdlinepart partitions found on MTD device spi0.0 [ 0.647415] Creating 6 MTD partitions on "spi0.0": [ 0.652285] 0x000000000000-0x000000040000 : "u-boot" [ 0.659357] 0x000000040000-0x000000050000 : "u-boot-env" [ 0.666314] 0x000000050000-0x000000060000 : "devdata" [ 0.673008] 0x000000060000-0x000000070000 : "devconf" [ 0.679646] 0x000000070000-0x000000ff0000 : "firmware" [ 0.719345] 0x000000ff0000-0x000001000000 : "radiocfg" [ 1.732792] switch0: Atheros AR8327 rev. 2 switch registered on ag71xx-mdio.0 [ 1.799647] libphy: ag71xx_mdio: probed [ 3.391236] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.0:00 [uid=004dd033, driver=Atheros AR8216/AR8236/AR8316] [ 3.402671] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:RGMII [ 3.411028] NET: Registered protocol family 10 [ 3.419183] NET: Registered protocol family 17 [ 3.423820] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this. [ 3.436672] Bridge firewalling registered [ 3.440862] 8021q: 802.1Q VLAN Support v1.8 [ 3.447760] VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6 [ 3.455394] Please append a correct "root=" boot option; here are the available partitions: [ 3.463882] 1f00 256 mtdblock0 (driver?) [ 3.469016] 1f01 64 mtdblock1 (driver?) [ 3.474154] 1f02 64 mtdblock2 (driver?) [ 3.479284] 1f03 64 mtdblock3 (driver?) [ 3.484424] 1f04 15872 mtdblock4 (driver?) [ 3.489554] 1f05 64 mtdblock5 (driver?) [ 3.494692] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0) [ 3.503948] Rebooting in 1 seconds..

The missing magic line seems to be: [ 0.715565] 2 seama-fw partitions found on MTD device firmware

I CAN install openwrt-15.05.1-ar71xx-generic-mynet-n750-squashfs-factory.bin, then sysupgrade to r813 sysupgrade image without a problem.

I built r813 with a test patch from jow: http://openwrt.crc.id.au/r813/EXTRA_PATCHES/00-try-to-fix-factory-images.patch

This did not fix the factory images. I tested as far back as r555 - which also did not boot correctly when flashed via the emergency httpsvr in uboot.