search

aqandu / airu-board

0 stars 1 forks source link

[Wearable] - Update physical dimensions #15

Open tbec opened 5 years ago

tbec commented 5 years ago

We need the wider dimension of the PCB to exactly match the PMS5003 PM sensor. We'll need to shave off about 1-2mm, but check.

We also need to remove the corners of the PCB so screws can go through. I'll have more info on that later.

tbec commented 5 years ago

Take out a circle on each corner, with the center of the circle at each corner of the PCB. Radius of the circle is 3.5mm