Closed cncmodeller closed 6 years ago
If your goal is to measure house power utilization, Tasmota is not the right solution. OEM has a few choices that would be much better for that purpose. I have an IotaWatt, which is a pretty complete system that embodies a lot of engineering effort. Tasmota is not going to give you anything close to that. If you want to see power on a device to two, I would use the Sonoff S31 (or POW). They work with Tasmota and are pretty cheap and reasonably accurate.
This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.
This issue will be auto-closed because there hasn't been any activity for a few months. Feel free to open a new one if you still experience this problem.
Hi Folks, Please can anyone advise what would be an appropriate sensor configuration and pin assignment to accept a 0-VCC input from this device connected as identified below? I can calibrate the MQTT output within Openhab, I just need to capture and send the voltage data.
ESP and Current Transformer
converted to DC with a bridge rectifier and smoothing capacitor...
Any thoughts would be much appreciated.
Many Thanks Barry M