search

arendst / Tasmota

Alternative firmware for ESP8266 and ESP32 based devices with easy configuration using webUI, OTA updates, automation using timers or rules, expandability and entirely local control over MQTT, HTTP, Serial or KNX. Full documentation at
https://tasmota.github.io/docs
GNU General Public License v3.0
21.75k stars 4.72k forks source link

Wemo+PIR motion Strange behavior #3300

Closed hwarang098tkd closed 5 years ago

hwarang098tkd commented 5 years ago

Hi all!!! II connect wemo d1 with pir motion sensor. G->G,VCC->5v,Out->D5. I configure the module in generic mode and d5 to switch1. When I start the module and trigger for the first time the sensor with motion I noticed that it cant un-trigger when there isn't motion. I have a voltmeter connect to d5 pin and stays with no motion at 2,73 volt and when it is trigger in 3,2 V. It cant return in the un-trigger condition with 0v. I tested with the same configuration with I switch and it is working fine. I also tested my pir motion and it is OK. what is going wrong? I followed the instructions [https://github.com/arendst/Sonoff-Tasmota/wiki/Wemos-D1-Mini-and-HC-SR501-PIR-Motion-Sensor](

reloxx13 commented 5 years ago

what is your Switchmode1 ?

should be Switchmode1 1

https://github.com/arendst/Sonoff-Tasmota/wiki/Understanding-SwitchMode-and-SwitchTopic#switchmode

hwarang098tkd commented 5 years ago

I did it. I changed anoder sensor and work fine. but it is functional the sensor I used to use.