Closed GoogleCodeExporter closed 8 years ago
Does it work fine without it ?
Original comment by martines...@gmail.com
on 22 May 2012 at 10:06
my project is like when i send sms "pompeon" led turn on and when i send sms
"pompeoff" led turn off this part work fine, but when i connect pir sensor with
gsm shield when i turn on gsm shield it turn on for few seconds then turn off
only when connect pirsensor i have also used adaptor 12v 1amp but same
problem....
Original comment by veezo200...@gmail.com
on 22 May 2012 at 10:44
If you run the sketch without PIR, check that it works fine and then you
connect the PIR. If the shield shut down can be an ampere problem. Does Arduino
still work after the shield power-off? Can be a problem of PIR?
Original comment by martines...@gmail.com
on 23 May 2012 at 9:59
when i run sketch without PIR shield work fine but when i connect pir with
shield it shutdown after few seconds.
The problem is that if i put code only for PIR like when sesnor detect anything
led turn on shield work fine, but when i put code of sms automation and pir
together then shield shut down and if i put code only for sms automation shield
work fine.
Original comment by veezo200...@gmail.com
on 23 May 2012 at 12:32
Original comment by martines...@gmail.com
on 11 Dec 2012 at 5:01
This issue section is not longer supported.
Please check the support page www.gsmlib.org
Original comment by martines...@gmail.com
on 6 Jul 2013 at 11:27
Original issue reported on code.google.com by
veezo200...@gmail.com
on 22 May 2012 at 4:56