search

arkypita / LaserGRBL

Laser optimized GUI for GRBL
http://lasergrbl.com
Other
1.25k stars 495 forks source link

laser engraver not homing and going past limits , this is the error message said to send to this site #1211

Open Merlinshabbit opened 3 years ago

Merlinshabbit commented 3 years ago

image

arkypita commented 3 years ago

Thanks for the report, is it something that happens always or sporadically?

The problem has already been reported to me, but it seems to be a problem with the Microsoft serial management libraries over which I don't have much control.

Merlinshabbit commented 3 years ago

This was first time . When I was taking some pix of plugs and moved the laser head to the middle to dona video of it turning on , it homes correctly all of sudden. I was asked by a support email I reached out to, tondo this and send it to them . Came to conclusion that it may of been a plug coming loose from movement and my zip tied were not right enough. But next project my laser works then stops burning 26% in to project, but kept moving . I tried again and worked . Curious about this Microsoft serial issue. Do you think I should have the buffer set to a lower setting? I mainly use the engraver for wood burning images .

On Fri, Dec 18, 2020, 5:58 AM arkypita notifications@github.com wrote:

Thanks for the report, is it something that happens always or sporadically?

The problem has already been reported to me, but it seems to be a problem with the Microsoft serial management libraries over which I don't have much control.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/arkypita/LaserGRBL/issues/1211#issuecomment-748022126, or unsubscribe https://github.com/notifications/unsubscribe-auth/ASFGPK4YQUKHFMW4YTTH2Y3SVMYUTANCNFSM4VABXTHA .