Describe the bug
I just wired up a new machine and when commissioning it I found a strange problem.
I can home no problem. When I move the X axis in a positive direction it works fine but when I try to move back again in the negative direction it goes positive instead.
Same with the Y axis.
The Z axis works fine both up and down.
I loaded a file after homing and then moved in the positive direction to about the centre of the table.
I then tried framing the loaded file and it frames correctly moving in a positive direction and a negative direction.
Have I done something wrong, any other way to test my setup?
Describe the bug I just wired up a new machine and when commissioning it I found a strange problem. I can home no problem. When I move the X axis in a positive direction it works fine but when I try to move back again in the negative direction it goes positive instead. Same with the Y axis. The Z axis works fine both up and down. I loaded a file after homing and then moved in the positive direction to about the centre of the table. I then tried framing the loaded file and it frames correctly moving in a positive direction and a negative direction. Have I done something wrong, any other way to test my setup?