Open brijeshpanara opened 5 years ago
It would be easier to do that on the image you want to engrave. Then import it using line to line mode.
Marino
I want to make a simple dotter using grbl laser insted of laser i use 2-3mm point bold marker and i want to make image design using dots only when laser is on my solenoid in place of laser is on and make a dot so i want gaping or spacing of more than 1mm so i want to reduce lines in mm but this is not reduced below 0 so this is the problem if you have any solution regarding this please suggest me.
On Sat 2 Feb, 2019, 6:18 AM e6910 <notifications@github.com wrote:
It would be easier to do that on the image you want to engrave. Then import it using line to line mode.
Marino
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/arkypita/LaserGRBL/issues/570#issuecomment-459916772, or mute the thread https://github.com/notifications/unsubscribe-auth/AtEV0XRDEoBRIYiusVKFThu0LFuM0dZDks5vJOB4gaJpZM4ae63i .
a milling machine would be easier. Usiing something like ESTLCAM each dot would be a drill.
Is this any software like grbllaser which is input of any image and conver into dots with specific spacing.
On Mon 4 Feb, 2019, 4:21 PM e6910 <notifications@github.com wrote:
a milling machine would be easier. Usiing something like ESTLCAM each dot would be a drill.
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/arkypita/LaserGRBL/issues/570#issuecomment-460204429, or mute the thread https://github.com/notifications/unsubscribe-auth/AtEV0b0ZldEsRqKt_ZuFGjUXiKlqrDBzks5vKBC4gaJpZM4ae63i .
I want line every 2 or 3 mm is this possible or possible for generate G-code please support me.