Tasmota KNX Toggle Push button always receive "ON" but Console Shown "ON" and "OFF"

Hi,

I am triggering the Tasmota KNX Push toggle button On and Off and it is shown successfully in console but I am only getting ON only even Console shown OFF event on my NODERED DEBUG. Whenever I trigger ON or OFF, it will always shown "ON".

PROBLEM DESCRIPTION

A clear and concise description of what the problem is.

REQUESTED INFORMATION

Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!

[ ] Read the Contributing Guide and Policy and the Code of Conduct
[ ] Searched the problem in issues
[ ] Searched the problem in the docs
[ ] Searched the problem in the forum
[ ] Searched the problem in the chat
[ ] Device used (e.g., Sonoff Basic): _____
[ ] Tasmota binary firmware version number used: _____
- [ ] Pre-compiled
- [ ] Self-compiled
- [ ] IDE / Compiler used: _____
[ ] Flashing tools used: _____
[ ] Provide the output of command: Backlog Template; Module; GPIO 255:
```
Configuration output here:
```

- [ ] If using rules, provide the output of this command: `Backlog Rule1; Rule2; Rule3`:

Rules output here:

- [ ] Provide the output of this command: `Status 0`:

STATUS 0 output here:

- [ ] Provide the output of the Console log output when you experience your issue; if applicable:
  _(Please use_ `weblog 4` _for more debug information)_

Console output here:



### TO REPRODUCE
_Steps to reproduce the behavior:_

### EXPECTED BEHAVIOUR
_A clear and concise description of what you expected to happen._

### SCREENSHOTS
_If applicable, add screenshots to help explain your problem._

### ADDITIONAL CONTEXT
_Add any other context about the problem here._

**(Please, remember to close the issue when the problem has been addressed)**

ascillato / Tasmota_KNX

Tasmota KNX Toggle Push button always receive "ON" but Console Shown "ON" and "OFF" #551

PROBLEM DESCRIPTION

REQUESTED INFORMATION