PCB version 2 checklist - Githubissues

atctwo / watch-II

Firmware for my custom smart-ish-watch, mark II

MIT License

1 stars 0 forks source link

PCB version 2 checklist #58

Closed atctwo closed 3 years ago

atctwo commented 3 years ago

Here's a list of things I should do when designing v2 of the PCB:

bugs

[x] switch transistor pinout
[x] add MCP9808T temperature sensor
[x] reverse tft header
[x] stemma qt pinout
[x] ground mcp23008 address pins
[x] usb-c data pins
[x] mcp73831 led source -> sink

improvements

[x] move side switch to left side of board (if possible)
[x] move reset button to bottom side of board
[x] switch fuel gauge to LC709203F
[x] change LED resistor footprints
[x] add 3v3, gnd, rx, tx pins
[x] remove dpad_enter transistor, replace with button to ground
[x] base resistors 1k -> 330R
[x] pcb shorting thing under resistors