Closed pebou closed 5 years ago
Did you find any issue to create this point ? Usually, the Gladys device state changes only if the Bluetooth message is well managed, but I assume to not check the bulb state, I trust the command sent by Gladys.
After further investigations, it might be a more Gladys (Gateway) issue. Gladys doesn't have a intermediary state for its buttons or seekbars (which might be interesting to add in Gladys v4) When the action isn't completed :
I'll close the issue if I don't find anything that might be related to the module :)
I'm not sure Gladys V4 will handle this kind of behavior. So I just did it now for the AwoX module. If the light is OFF and you change the color, the light will be ON (on Gladys device page too). Available ASAP.
After sending a request to the bulb, check if the command has been received, and well interpreted : check if the new status is correct. Might be related to #9