Some issues with print status screen

[natsgo]

Running on a KE:

1. Volumetric extrusion rate numbers are overlapping the icon
2. Z height and layer number not showing
3. Print progress bar could be a bit lower so it is aligned with the bottom of time remaining box
4. Is there a way to fit the model image as it is cropped

Thanks for all your hard work on this. Really appreciate it.

[ballaswag]

Will look at scaling those for the smaller screen as well. Layer is broken with some slicers, will note as a todo.

[natsgo]

Thanks.

I am using orcaslicer btw.

[SSPW]

[natsgo] i was hoping the Z on this screen was current Z height. But the code shows it is Z-offset.

[ballaswag] i would suggest that Z-height would be a much better value on this progress screen.