The current functionality when there is and error feeding or retracting filament from the hotend, I am only presented with the options to 'retry' or cancel the print.
Retry will once again attempt to load / unload the filament. However, I have discovered an issue where i would need to remove the filament and fix -whatever- problem, and I am unable to command the spool to unload.
When a print is paused, REGARDLESS OF AMS STATUS OR RETRY STATE, i should be able to command the spool to load or unload so I can remove the spool and not have filament in the entire feed path.
It is very frustrating to KNOW i need to rework a PTFE tube but I have no way to truly unload the spool because the AMS motor is locked, and retry will only attempt to load / unload the entire path. Otherwise i need to manually pull the filament out past the motor tension.
The current functionality when there is and error feeding or retracting filament from the hotend, I am only presented with the options to 'retry' or cancel the print.
Retry will once again attempt to load / unload the filament. However, I have discovered an issue where i would need to remove the filament and fix -whatever- problem, and I am unable to command the spool to unload.
When a print is paused, REGARDLESS OF AMS STATUS OR RETRY STATE, i should be able to command the spool to load or unload so I can remove the spool and not have filament in the entire feed path.
It is very frustrating to KNOW i need to rework a PTFE tube but I have no way to truly unload the spool because the AMS motor is locked, and retry will only attempt to load / unload the entire path. Otherwise i need to manually pull the filament out past the motor tension.