When spools are too low (about 200g or less), the AMS will launch the spool out of its spot. I noticed though that if you just disengage the gear that keeps the filament in tension then it will be fine. Right now it keeps it so tight and pulls on it so hard that it gets pulled up and forward.
If you guys could please change it so that the gear unwinds slightly or anyway to disengage that gear itself just briefly. It doesn't need much just a slight turn and it won't get launched up against the AMS lid. Thanks.
When spools are too low (about 200g or less), the AMS will launch the spool out of its spot. I noticed though that if you just disengage the gear that keeps the filament in tension then it will be fine. Right now it keeps it so tight and pulls on it so hard that it gets pulled up and forward.
If you guys could please change it so that the gear unwinds slightly or anyway to disengage that gear itself just briefly. It doesn't need much just a slight turn and it won't get launched up against the AMS lid. Thanks.