Open Shedalizzm opened 2 months ago
Same problem here, it start after the new firmware.
Solved the problem hear, at last i don't get the issue for now.
I solved removing ALL PTFE TUBEs and re-organizing one by one to do less curve possible.
And now problem appear to be solved. ( NOT SOLVED )
UPDATE:
Not Solved. problem continue.
I tried now decrease the TRAVEL SPEED and TRAVEL ACCELERATION, because i found that going SILENT MODE the problem do not happen.
So i decreased my travel speeds and i do not have the problem until now.
Travel speed 700
Travel acceleration 10000
Before
2000 and 200000 ( i think this are the problem before )
@Shedalizzm After turning off the nozzle clumping detection, we will still perform the clumping detection at the third layer
Bambu Studio Version
1.9.2.57
Where is the application from?
Bambu Lab Official website
OS version
Windows 10 Home
Additional system information
No response
Printer
Bambulab A1 Mini
How to reproduce
When printing the "Nozzle clumping detection" move is done even if I have disabled it in "Print options" on the screen on the printer
Actual results
After the first few layers, print head goes off to the side of the print bed and lowers down to check for clumping. This happens when its enabled but also when its disabled.
Expected results
The nozzle clumping detection movement should not happen when its turned off.
Project file & Debug log uploads
Nozzleclumpingproblem.zip bambulog.zip
Checklist of files to include