When using the AMS there is quite a lot of filament waste for multi color (or material) prints. By allowing the slicer to 'flush' the filament on parts where bleeding does not matter, the waste could be drastically reduced.
For instance have a setting to use the flush filament for the infill parts after a 2 mm outer layer.
Or allow selection of objects which do not care about bleed. Like some inner parts of a multi part model.
When using the AMS there is quite a lot of filament waste for multi color (or material) prints. By allowing the slicer to 'flush' the filament on parts where bleeding does not matter, the waste could be drastically reduced.
For instance have a setting to use the flush filament for the infill parts after a 2 mm outer layer.
Or allow selection of objects which do not care about bleed. Like some inner parts of a multi part model.