search

bancika / diy-layout-creator

multi platform circuit layout and schematic drawing tool
http://diy-fever.com
GNU General Public License v3.0
914 stars 100 forks source link

Curved traces are too round #384

Closed gtranter closed 5 years ago

gtranter commented 5 years ago

Since v3.43.0 the corner radius of curved traces with three points (four points as well) has increased a great deal. This causes them to be too close to things - usually pads - that I am trying to route around and makes them unusable. Pretty much all of my layouts are no longer usable as a result. Please restore the original radius. Attached is a small example where curved traces have become unusable around square pads in my layouts.

gtranter commented 5 years ago

The attachment and edit features won't work so here's a link to the example image: https://imgur.com/a/OY9f4tK.

bancika commented 5 years ago

Thanks for reporting. But are you sure about four-point curve? I can see that I changed the behavior of 3 point curves and I'll change that for the next release. But don't think it's there for four-point curv.e Cheers

bancika commented 5 years ago

Can you please try the latest release and see if it works ok for you? It should

gtranter commented 5 years ago

The three-point works great now. I'll have to try the 4-point again when I get home, but I think it was a problem when both inner points were together (as if it were only 3 points). I don't use them very much so it's not a big deal to me. Thanks.

Yes - 4 point are fine and were never a problem.