search

barovehicles / lita-carrier-board

2 stars 1 forks source link

Jetson TX2 NX #2

Open marianbrunet opened 3 years ago

marianbrunet commented 3 years ago

Hi! I have a Lita board and a Jetson TX2 NX module. I have tried the 0.Installation guide. I am unable to have a few peripherals working (WiFi, USB 3.0, MIPI camera). I have used the firmware for Jetson Xavier NX (developer and production module) + Camera Sony IMX219. Is there anything else I should do? Thank you

barovehicles commented 3 years ago

Hi. For the TX2 NX you need to use the TX2 NX firmware. The other firmware didn't works. Let me see with my engineer to share the TX2 NX firmware. About USB 3.0 is provided through the blue connector. Then is necessary to assemble the USB connector or use something similar to this: https://www.amazon.com/RIITOP-Female-Connector-Adapter-Bracket/dp/B01KJPUI5W/ref=sr_1_25?dchild=1&keywords=usb+3+connector&qid=1635226959&sprefix=usb+3+connector%2Caps%2C260&sr=8-25

About the WIFI the board don't have wifi only bluetooth. We are preparing a shield to connect in the USB to have wifi and usb at the same time.

marianbrunet commented 3 years ago

Hi, I have tested with a Jetson Nano module and the USB port works. I will keep an eye out for the TX2 NX firmware.

Thank you.

gabgiani commented 2 years ago

In the version lita 2.93 was solved the issue. Tested with your camera Intel! I hope this works for you! Thanks