The PRINT_END macro leaves substantial stringing that requires post-processing with a cutter to remove.
To Reproduce
Lay out two copies of any small model on the plate in slicer.
Set print settings to print each object on the plate individually. This is to demonstrate the stringing issue comes from the PRINT_END macro. In PrusaSlicer, this is the "Complete individual objects" setting.
Start and finish print.
Expected behavior
The object at the end of the print should have minimal stringing from where the nozzle leaves the last layer.
Screenshots
N/A
What printer are you using?
SV06
What kind of device are you using to host Klipper?
Raspberry Pi 2b.
How did you install Klipper?
MainsailOS.
Is your local copy of this configuration up to date?
The PRINT_END macro leaves substantial stringing that requires post-processing with a cutter to remove.
To Reproduce
Expected behavior The object at the end of the print should have minimal stringing from where the nozzle leaves the last layer.
Screenshots N/A
What printer are you using?
SV06
What kind of device are you using to host Klipper?
Raspberry Pi 2b.
How did you install Klipper?
MainsailOS.
Is your local copy of this configuration up to date?
2023-12-12 pull of this repo.
What slicer are you using?
PrusaSlicer.
Are you using the config bundles from this repo?
Yes.
Did you Adjust your slicer?
Yes.
Additional context Printing Elegoo PLA at 210C with 96% extrusion multiplier.