search

bassamanator / Sovol-SV06-firmware

🔥 A comprehensive Klipper configuration for a variety of 3D printers 🔥
GNU Affero General Public License v3.0
886 stars 78 forks source link

Questions Related to this Repo / Unknown Commands #77

Closed Chewyyy closed 1 year ago

Chewyyy commented 1 year ago

Hi!

I just did a clean install of Mainsail OS and followed only your instructions and am using your macros / firmware setup. I have also gone into Cura and setup the Gcode before/after prints as recommended. I have done all the calibrations and have everything working, but just have a few "issues".

During prints, my console window is being spammed with "Unknown command" errors for M205 and AFTER_LAYER_CHANGE and BEFORE_LAYER_CHANGE. Additionally, when I initially start a print, I get the same Unknown command error, but for "PRINT_START_SET"and "PRINT_START_SET". I've attached the logs.

I appreciate any and all assistance! Thanks in advance! klippy (3).log

Chewyyy commented 1 year ago

M205 issue was the acceleration controls got turned on in Cura. I'm assuming the Print_start_set and before/after layer change is a similar setting. If you happen to know which setting, it'd be greatly appreciated!

Chewyyy commented 1 year ago

It ended up being macros that were nested into Cura. Nothing to do with your wonderful firmware set! Sorry for wasting your time!

bassamanator commented 1 year ago

@Chewyyy No worries! 😁