bkenobi
commented
7 years ago It looks like going into AP mode requires uncommenting some lines of code in the wifi_setup function.
Now that that works, I'll have to figure out how to connect to it again to set up the RFM settings and whatnot. It's currently default (915MHz, etc) and needs changing. When I connect to the listed IP, it doesn't go.
`RFM69 WiFi Gateway External System WM: settings invalidated WM: THIS MAY CAUSE AP NOT TO START UP PROPERLY. YOU NEED TO COMMENT IT OUT AFTER ERASING THE DATA. WM: WM: AutoConnect WM: Connecting as wifi client... WM: Using last saved values, should be faster WM: Connection result: WM: 0 WM: SET AP STA Entered config mode 192.168.4.1 RFM69-AP WM: WM: Configuring access point... WM: RFM69-AP WM: AP IP address: WM: 192.168.4.1 WM: HTTP server started WM: Handle root WM: Request redirected to captive portal WM: Handle root WM: Request redirected to captive portal WM: Handle root WM: Handle root WM: Handle root WM: Request redirected to captive portal WM: Handle root WM: Scan done WM: Linksys_1 WM: -76 WM: Linksys_2 WM: -77 WM: Sent config page WM: Scan done WM: Linksys_2 WM: -78 WM: Linksys_1 WM: -78 WM: Sent config page WM: Sent config page WM: Info WM: Sent info page WM: Scan done WM: Linksys_1 WM: -75 WM: Linksys_2 WM: -78 WM: Sent config page WM: WiFi save WM: Sent wifi save page WM: Connecting to new AP WM: Connecting as wifi client... WM: Connection result: *WM: 3 connected MDNS responder started Connect to http://rfm69gw1.local or http://192.168.0.48
Listening at 915 91 MHz Attempting MQTT connection...failed, rc=-2 try again in 2 seconds Attempting MQTT connection...failed, rc=-2 try again in 2 seconds Attempting MQTT connection...failed, rc=-2 try again in 2 seconds`
boaschti
I am just getting started with the sketch, but it looks like I should just be able to upload it to the ESP and configure once it's started. I am able to load the sketch, compile, and upload to both NodeMCU v3 and Wemos D1 without issue. Once uploaded, the serial monitor does not provide much help.
`RFM69 WiFi Gateway External System e sketch, but it looks like I should just be able to upload it to the ESP and configure once it's started. I am able to load the sketch, compile, and upload to both NodeMCU v3 and Wemos D1 without issue. Once uploaded, the serial monitor does not provide much help.
With no router in the area: `RFM69 WiFi Gateway External System connected MDNS.begin failed Connect to http://rfm69gw1.local or http://0.0.0.0
Listening at 915 91 MHz Attempting MQTT connection...failed, rc=-2 try again in 2 seconds Attempting MQTT connection...failed, rc=-2 try again in 2 seconds Attempting MQTT connection...`
It looks like the ESP is not starting in AP mode and failing to connect to a router. Other than attempting to rewrite code that I'm not overly familiar with, I'm not sure where to go.