Open Davinjw opened 7 months ago
Your frame is probably naturally out square. The homing process squares it, but when the motors disable it might pop back to the out of square position. It is probably just moving the easiest side.
Change the idle_ms: value to 255. This will keep the motors enabled at all times.
Wiki Search Terms
pulloff pull off homing ganged square
Controller Board
MKS Tinybee
Machine Description
laser table, ganged Y axis and single X axis motor
Input Circuits
No response
Configuration file
Startup Messages
User Interface Software
No response
What happened?
If I home the machine, X homes correctly, Y homes correctly, then immidiately following this one of the ganged Y motors moves in the positive direction a couple millimeters while the second does not.
GCode File
No response
Other Information
No response