I am trying to add a PWM laser to my existing system that uses a RS485. I try to compile a new config and load and seem to have some issues. Is it possible to have both a laser and a spindle in the configuration and switch between them by changing the physical switch from rs458 to pwm?
User Interface Software
Fluidterm
What happened?
Grbl 3.7 [FluidNC v3.7.6 (wifi) '$' for help]
ets Jun 8 2016 00:22:57
[MSG:INFO: FluidNC v3.7.6]
[MSG:INFO: Compiled with ESP32 SDK:v4.4.4]
[MSG:INFO: Local filesystem type is littlefs]
[MSG:INFO: Configuration file:config.yaml]
[MSG:ERR: ERR: gpio.4 - Pin is already used.]
Guru Meditation Error: Core 1 panic'ed (LoadProhibited). Exception was unhandled.
Wiki Search Terms
Adding a PWM laser while having RS485 Spindle
Controller Board
XPro V5
Machine Description
Workbee dual y motor, spindle with vfd
Input Circuits
No response
Configuration file
Startup Messages
User Interface Software
Fluidterm
What happened?
Grbl 3.7 [FluidNC v3.7.6 (wifi) '$' for help] ets Jun 8 2016 00:22:57
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:1 load:0x3fff0030,len:1184 load:0x40078000,len:13220 ho 0 tail 12 room 4 load:0x40080400,len:3028 entry 0x400805e4
[MSG:INFO: FluidNC v3.7.6] [MSG:INFO: Compiled with ESP32 SDK:v4.4.4] [MSG:INFO: Local filesystem type is littlefs] [MSG:INFO: Configuration file:config.yaml] [MSG:ERR: ERR: gpio.4 - Pin is already used.] Guru Meditation Error: Core 1 panic'ed (LoadProhibited). Exception was unhandled.
GCode File
No response
Other Information
No response