Closed Amir2367 closed 6 months ago
Hi,
Every time you run the command, you need to give the full command. Even after exit, when you run again, you need to give the full command.
The best command I recommend you use is warp-plus --scan --gool
Hi,
Every time you run the command, you need to give the full command. Even after exit, when you run again, you need to give the full command.
The best command I recommend you use is
warp-plus --scan --gool
Thanks for your Support ❤️
Hi Mark, I tested the version you posted in Actions (warp: refactor identity creation)
1_ The first movie (when I enter the command warp-plus-4 and when we exit, the IPs are again broken and and it connects with IP v6, while it should be connected with v4)
2_ The second movie (sometimes it brings IP v6 first, if there is a problem with the shatel and mci with ipv6 and the config doesn't connect)
3- The third movie (by entering the warp-plus -e command, when we want to change the IP and port, the IP does not change and the IPs of the boiler are connected).
https://github.com/bepass-org/warp-plus/assets/83357422/1b098495-0d6d-4a8e-855f-a8b5ac318d48
https://github.com/bepass-org/warp-plus/assets/83357422/cdf51788-5ab9-4c9a-9b2d-f1c03831d0d9
https://github.com/bepass-org/warp-plus/assets/83357422/7a39c97c-77ca-4e48-8c10-5c55a0e55313