I have a 7 Zoll drone and used a Radiomaster RP3 Express LRS Reciver with a Mamba F405 MK2 Board and all worked. Now I changed the Board to a SPEEDYBEEF7V3 connected all togeter and flashed the firmware. But the Receiver did not get any signal. I checked wirering several Times. TX is on RX and RX on TX, 4.5V on Reciver and GND on GND.
I checkt the Config in Betaflight also several times its CRSF selected an UART2.
It´s
s connected her:
I really don´t understand why it´s not working.
To Reproduce
Use the SPEEDYBEEF7V3 with Radiomaster RP3 Express LRS Reciver
Expected behavior
Get Signal because of right connection
Support ID
0x2c001e3232510638393431
Flight controller
SPEEDYBEEF7V3
Other components
Radiomaster RP3 with Exrpress LRS (already worked on the old board)
GPS, O3
How are the different components wired up (including port information)
No response
Add any other context about the problem that you think might be relevant here
Describe the bug
I have a 7 Zoll drone and used a Radiomaster RP3 Express LRS Reciver with a Mamba F405 MK2 Board and all worked. Now I changed the Board to a SPEEDYBEEF7V3 connected all togeter and flashed the firmware. But the Receiver did not get any signal. I checked wirering several Times. TX is on RX and RX on TX, 4.5V on Reciver and GND on GND. I checkt the Config in Betaflight also several times its CRSF selected an UART2.
It´s s connected her:
I really don´t understand why it´s not working.
To Reproduce
Use the SPEEDYBEEF7V3 with Radiomaster RP3 Express LRS Reciver
Expected behavior
Get Signal because of right connection
Support ID
Flight controller
SPEEDYBEEF7V3
Other components
Radiomaster RP3 with Exrpress LRS (already worked on the old board) GPS, O3
How are the different components wired up (including port information)
No response
Add any other context about the problem that you think might be relevant here
No response