Closed roninf closed 1 year ago
addition: remote.nz8_remote
last_commands_sent: power last_commands_response: standby power_state: standby signal_state: unknown input_state: unknown lamp_state: high picture_mode: unknown friendly_name: NZ8_remote supported_features: 0
I know its standby here .. but it does not change when the projector is running
Does it have to be "lamp_state" or "lamp" .... i changed it to lamp according to the documentation... maybe thats the "issue"... i`ll check that later on.
Yes it should be "lamp". The logs are on the first set, the projector is refusing communication and in the second set, it is not sending the required responses for the low_latency and picture_mode commands. Is your projector on the "new" firmware that was released by JVC by any chance?
Yes its on the new firmware (2.0)... but "picture_mode" and the remote do still work fine. I can change the lasermode, picturemode and latency just fine using the remote. Lamp state is not shown anymore since its "lamp" instead of "lamp_state" at least thats my guess. And i just added latency 2 days ago so i don`t know if it would have worked before.
My apologies, I have looked over your posts in more detail and the problem is clear.
state_attr('remote.nz8_remote', 'SOME_ATTR')
will only work with attributes that are exposed via the remote device (follow the link to see what is possible).
You are mixing up commands which can be directly sent to the projector via the remote.send_command
service and the attributes that are stored in the remote device. In this case, lamp_state
is the correct format to use, as that is the name of the attribute. Internally, the remote component sends a command lamp
(which is found in the README) to the projector. The result is interpreted and stored in the lamp_state
attribute.
Since a low_latency
attribute has not yet been implemented, you will need to write an automation which uses the remote.send_command
service to send the command low_latency
and then use state_attr('remote.nz8_remote', 'last_commands_response')
to retrieve the value.
Perfect thanks for clarification!
Not working:
Picture Mode for example is still working fine:
Here are some HA logs (not sure if they are related to the issue):