I'm pretty sure the DIAG pin on the EZ2209 driver is causing my endstops not to trigger (or stay triggered, depending on which state I choose (high or low), while using the internal pullup - Marlin fw). On your TMC2201V1.2 you talk about this exact issue and your solution is to cut the DIAG pin. I'm using an Octopus MAX EZ with your EZ2209 drivers, so there is no pin to cut. Any suggestions on how to disable this pin?
I'm pretty sure the DIAG pin on the EZ2209 driver is causing my endstops not to trigger (or stay triggered, depending on which state I choose (high or low), while using the internal pullup - Marlin fw). On your TMC2201V1.2 you talk about this exact issue and your solution is to cut the DIAG pin. I'm using an Octopus MAX EZ with your EZ2209 drivers, so there is no pin to cut. Any suggestions on how to disable this pin?