search

bigtreetech / BIGTREETECH-GTR-V1.0

BIGTREETECH GTR V1.0 motherboard is a high-performance 3D printer main control board with the core controller STM32F407IGT6, which was launched by the 3D printing team of ShenZhen BigTree Technology CO.,LTD ., aiming at solving some problems existing in the motherboard market. The BIGTREETECH GTR V1.0 is the motherboard, and the BIGTREETECH M5 V1.0 is the expansion board.
90 stars 55 forks source link

Klipper and gtr #37

Closed shawnp30 closed 3 years ago

shawnp30 commented 3 years ago

Has anyone successfully compiled gtr with klipper. I get lost after trying to find mcu. I have followed links to use gnd and tx and rx on the li and gtr. I have disabled serial and usb as klipper and btt suggested. Still cannot find mcu. My pi and board seem to not be communicating what can I do to get this working.

BronsonMMiller commented 3 years ago

Wow what a wonderful and vibrant community GTR has here. Oct 2020 and not one answer to such a simple question? I should just return this funkkin' board to amazon while I still can...

dzhaparoff commented 3 years ago

BTT do not care about post sale support... And GTR is not so common used board, community is very small.

shawnp30 commented 3 years ago

My gtr works just fine. It was an error on my part. Gtr is one of the best boards for buck to use. The fact I can run all my motors for corexy triple z in one board with room for an expansion board works perfectly.