BIGTREETECH GTR V1.0 motherboard is a high-performance 3D printer main control board with the core controller STM32F407IGT6, which was launched by the 3D printing team of ShenZhen BigTree Technology CO.,LTD ., aiming at solving some problems existing in the motherboard market. The BIGTREETECH GTR V1.0 is the motherboard, and the BIGTREETECH M5 V1.0 is the expansion board.
Has anyone gotten Pid Autotune to work with Raspberry Pi and the GTR?
I had issues with it connecting to the Raspberry Pi pins - I know to not use all the pins and only the power/rx/tx but this still didn't work when connecting to the GTR. So I plugged it with the classic USB cable.
GTR works with Raspberry Pi and USB cable, can run everything fine EXCEPT for Pid Autotune functions. Bed and Nozzles heat up, yet I can't run Autotune and it just throws an error after not receiving info from GTR.
Has anyone gotten Pid Autotune to work with Raspberry Pi and the GTR?
I had issues with it connecting to the Raspberry Pi pins - I know to not use all the pins and only the power/rx/tx but this still didn't work when connecting to the GTR. So I plugged it with the classic USB cable.
GTR works with Raspberry Pi and USB cable, can run everything fine EXCEPT for Pid Autotune functions. Bed and Nozzles heat up, yet I can't run Autotune and it just throws an error after not receiving info from GTR.
Anyone get this to work?