Hi all,
I would like to connect my NEMA 23 to the Octopus Pro.
I have the drivers for them which are (by title) TB6560.
I would like to know which set up should I use since I changed some information in the code (changing the driver), but I think I am missing something in the jumper set and probably in the wiring too.
I used a sort of "blank" drivers to attach the externa ones (the one in the picture).
From that I used the same wiring setup I had on a another board I used to use with raspberry (the protoneer). but it does not move at all.
Hi all, I would like to connect my NEMA 23 to the Octopus Pro. I have the drivers for them which are (by title) TB6560.
I would like to know which set up should I use since I changed some information in the code (changing the driver), but I think I am missing something in the jumper set and probably in the wiring too.
I used a sort of "blank" drivers to attach the externa ones (the one in the picture).
From that I used the same wiring setup I had on a another board I used to use with raspberry (the protoneer). but it does not move at all.
I have for now all the jumpers under the driver.