WiFi card ESP8266, ESP-07S Setup Instructions For Marlin Needed

bigtreetech / BIGTREETECH-OCTOPUS-V1.0

This is Octopus open source material

554 stars 328 forks source link

WiFi card ESP8266, ESP-07S Setup Instructions For Marlin Needed #109

Open Aurawin opened 2 years ago

Aurawin commented 2 years ago

Can someone point me to the instructions to setup my WiFi ESP8266 ESP-07S with the V1.1 board?

WesMcGee68 commented 2 years ago

install of the BTT ESP32 install on Octopus v1.1 needed also....

lukasloetkolben commented 1 year ago

ESP3D is working for me.

In Marlin Configuration.h:

#define SERIAL_PORT_2 3
#define BAUDRATE_2 250000

Connect the ESP07S to a USB to TTL Adapter:

TXD0 -> RX
RXD0 -> TX
VCC -> 3.3V
GND -> GND
RST -> 3.3V
EN -> 3.3V
IO0 -> GND
IO2 -> 3.3V
IO15 -> GND

Clone https://github.com/luc-github/ESP3D Download VS Code (+ PlatformIO) and compile ESP3D & flash it to ESP07S. If its not possible to flash with PlatformIO use ESP8266 DOWNLOAD TOOL with this config:

CrystalFeq: 24M
SPI SPEED: 40MHz
SPI MODE: QIO
FLASH SIZE: 32Mbit

ESP07S-Pinout

Aurawin commented 1 year ago

The module needs to be flashed before you can use it. And before you can flash it you need to configure it. The WiFi is too slow to use for uploading large prints. Consider all the new options like Manta 4/8P with CB1.

lukasloetkolben commented 1 year ago

The module needs to be flashed before you can use it. And before you can flash it you need to configure it. The WiFi is too slow to use for uploading large prints. Consider all the new options like Manta 4/8P with CB1.

The upload is not slow because of the wifi, it is because of the communication between ESP and Marlin.

WesMcGee68 commented 1 year ago

Yes I did get it worked out..

Sent from Mailhttps://go.microsoft.com/fwlink/?LinkId=550986 for Windows

From: @.> Sent: Saturday, September 3, 2022 9:24 AM To: @.> Cc: @.>; @.> Subject: Re: [bigtreetech/BIGTREETECH-OCTOPUS-V1.0] WiFi card ESP8266, ESP-07S Setup Instructions For Marlin Needed (Issue #109)

have you found a way to use WiFi ESP8266 ESP-07S with the V1.1 board?

— Reply to this email directly, view it on GitHubhttps://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/issues/109#issuecomment-1236119994, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AY3IX66DWM4PZNB57F6FUEDV4NGRBANCNFSM5PJIJKYA. You are receiving this because you commented.Message ID: @.***>

Erfan017 commented 9 months ago

you can use this for esp32u also i used arduino uno as a programmer and programmed my esp32u for my octopus pro