Open JanSimancik opened 2 years ago
I have run into the same problem. It only started when I swapped my Octopus Pro for an Octopus 1.0 board. I have been all over this problem and can't figure it out. One thing I noticed on mine, is that my Unable to read tmc uart 'stepper_x' register IFCNT code only came up after flashing my board from a firmware I had put together. With the Octopus Pro, I had used BTT pre-made firmware (USB446) and everything worked fine. Now, I cannot get my machine to work with BTT version of the firmware.
Hello, Unfortunately I have since yesterday exactly the same problem with my SKR 2. Driver TMC 2209. Funny is only it ran well for 3 months now comes this problem. Can no longer home'n. UART pin are all correct. Replacement of the drivers in 2208 brought no improvement. I don't know what else I can do.
I had similar issue and solved . You need to connect "motor input 24v pins in octopus board" directly from power supply ..
Yo tengo el mismo problema con mi btt manta m8p en el motor de lextrusor y en el z3, encontraron la solucion?
I had similar issue and solved . You need to connect "motor input 24v pins in octopus board" directly from power supply ..
Fixed my issue - thanks.
I had similar issue and solved . You need to connect "motor input 24v pins in octopus board" directly from power supply ..
Can you define exactly what that means? I am seeing the same error on a new SKIPR board with TMC2209s under fluidd...
Hello, today I try to spin up my new BTT Octopus V1.1 board with sensorless homing , TMC 2209 in UART. I have jumpers in right position for all drivers. DIAG0 & 1 are connected by jumpers but every time when I try to home, it just trow the error Unable to read tmc uart 'stepper_x' register IFCNT. i try different configurations but nothing help. After some tries I move to Unable to read tmc uart 'stepper_z' register IFCNT which was not helpfull at all :( .\
FIRMWARE: Klipper v0.10.0-456 PSU: 2x - 24V for Bed and 24V for Board/Drivers Drivers: TMC2209 v1.2
Drivers works fine on a BTT SKR2 with same configuration ( Sensorless - TMC2209 UART ).
UPDATE: Right now only stepper z is working corectly. X,Y and E0 have same issue with UART.
Endstops query is still showing triggered X and Y.