Steppers not moving with stock firmware

bigtreetech / BIGTREETECH-OCTOPUS-V1.0

This is Octopus open source material

562 stars 335 forks source link

Steppers not moving with stock firmware #49

Open mechanical-girl opened 3 years ago

mechanical-girl commented 3 years ago

Connected my Octopus V1.1 to my Ender 3 Pro. Using TMC2209 steppers in standalone mode.

Steppers aren't moving when given GCODE commands via OctoPrint or via the connected LCD.

Seminole81 commented 3 years ago

I have similar issue. Extruder not working with TMC2209 in UART mode. X, Y, and Z are moving however, and when I swap them then the extruder WILL work, but the one it swapped with will not work.